# Freeze Dragon Liquideo, which tank and which settings for each bottle

> Freeze Dragon Liquideo in a vape tank, MTL for the 10 ml, sub-ohm for the shortfill with a nic shot, strengths worked out, priming and coil life.


**Freeze Dragon Liquideo** comes in two bottles, a ready to vape 10 ml and a 50 ml shortfill. On the product pages they look alike, with the same dragon fruit, the same icy mint and the same base. In a vape tank, though, they do not lead to the same tank or the same settings. Pair them badly and the coil drowns out the fruit, runs too hot or wears out before the bottle is empty. This guide starts from the bottle and works up to the tank.

## Freeze Dragon Liquideo, which tank for each bottle

The 10 ml of **Freeze Dragon Liquideo** belongs in a mouth to lung (MTL) tank, on a coil of 1 ohm or more set to a low wattage. Once a nic shot has gone in, the 50 ml shortfill suits a sub-ohm tank with a more open draw and a low final strength. Either kind of tank takes the 50/50 base of both formats.

This split follows the manufacturer. Liquideo presents its 10 ml as ready to vape, for pods and tight draw MTL kit, and lists the 50 ml for pods, MTL or sub-ohm. The table sums up both routes.

| Bottle | Nicotine strength | Tank | Coil | Draw |
|---|---|---|---|---|
| 10 ml ready to vape | 0, 3, 6 or 10 mg/ml | MTL | 1 ohm and above | tight |
| 50 ml with nic shot | 2.86 to 5.71 mg/ml | sub-ohm | below 1 ohm | open |

## The 10 ml in a mouth to lung tank

The small bottle leaves the factory with its nicotine strength already set, from 0 to 10 mg/ml. There is nothing to mix, so everything comes down to the tank, the coil and the airflow.

### A higher resistance and a low wattage

Mouth to lung coils, most often between 1 and 1.8 ohms, run at a few watts, between 8 and 15 W for most of them. Start at the bottom of the range printed on the coil. Dragon fruit is a light note, and too much power mostly lets the mint through. Our guide to [vape coil ohms and watts](/uk/vape-coil-ohms-and-watts/) explains how resistance and wattage relate.

A 50/50 base is thin enough for the wick of an MTL coil. The liquid reaches the cotton easily, which keeps dry hits to a minimum.

### Airflow almost closed

For a tight draw, the airflow ring is set to a very small opening. Little air comes in, the vapour stays warm and dense, and the fruit keeps its place next to the cooling note. Opening it wider does not turn an MTL tank into a sub-ohm one, as our guide to [MTL and DTL vaping](/uk/mtl-and-dtl-vaping/) explains.

## The 50 ml shortfill in a sub-ohm tank

The large format arrives at 0 mg in a 70 ml bottle, which leaves 20 ml of space for one or two nic shots. That volume is what points it towards sub-ohm vaping, where a low resistance coil goes through far more liquid than a tight draw does.

### Three mixes, three strengths

The figures below assume 10 ml nic shots at 20 mg/ml, the UK maximum for nicotine e-liquid, which is also sold in bottles of 10 ml at most. One shot adds 200 mg of nicotine, two add 400.

| Mix | Final volume | Final strength |
|---|---|---|
| 50 ml + 1 nic shot | 60 ml | 3.33 mg/ml |
| 50 ml + 1 nic shot + 10 ml of unflavoured base | 70 ml | 2.86 mg/ml |
| 50 ml + 2 nic shots | 70 ml | 5.71 mg/ml |

The middle row fills the bottle without going above 3 mg/ml. The unflavoured base dilutes the flavour slightly, but it opens the door to coils whose spec sheet sets a nicotine ceiling.

### What a sub-ohm coil asks for

Geekvape's official page for its Z XM coils, Boost version, gives an example of such guidance. They run at 70 to 85 W in 0.15 ohm, 70 to 80 W in 0.2 ohm and 50 to 60 W in 0.4 ohm. Geekvape advises freebase e-liquid at 3 mg/ml or less and advises against nicotine salts.

With this kind of coil, the 2.86 mg/ml mix fits, the 3.33 mg/ml mix goes slightly over and the 5.71 mg/ml mix clearly does. Nic shots are therefore chosen with the coil's spec sheet in mind, not only the flavour. These coils fit any tank that takes Z coils, such as the [Z Sub Ohm 2021 tank](/uk/geekvape-z-sub-ohm-2021-tank/).

## Priming the coil before the first fill

A new coil needs to be soaked before it is fired. Otherwise the dry cotton scorches in a single puff, and the burnt taste stays, whatever the liquid.

### Three methods, one wait

There are three ways to prime these heads. The simplest is to fill the tank, then wait 3 to 5 minutes for the cotton to saturate. You can also drip a few drops of liquid onto the cotton through the coil's wicking holes before screwing it in, or take a few gentle puffs with the device switched off and the airflow reduced.

For the shortfill, the first fill comes after mixing. The e-liquid maker asks you to pour in the nic shot, shake the bottle hard and wait a few minutes before vaping.

### The first wattage

Once the coil is primed, start at the bottom of its range, then go up in small steps. A 50/50 base soaks in faster than a high VG liquid, which is thicker, slower to wick and quicker to cause buildup.

## How many tank fills in a bottle of Freeze Dragon Liquideo

In the UK, a refillable tank holds 2 ml at most. Every bottle can therefore be counted in tank fills, which also gives a benchmark for the coil.

### The bottle counted in 2 ml fills

A 10 ml bottle fills a 2 ml tank five times. The shortfill with one nic shot gives thirty fills, and either 70 ml mix thirty-five. In its large format, **Freeze Dragon Liquideo** means a long run of refills on the same tank.

### The coil counted in millilitres

A Z XM coil typically lasts 50 to 60 ml of e-liquid according to Geekvape, depending on how often it is used, the type of liquid and vaping habits. That is 25 to 30 fills of 2 ml, fewer than the 35 in a 70 ml bottle. Plan to change the coil before the end of a large bottle rather than waiting for a burnt taste.

With a tight draw, consumption is far lower and a coil lasts for more fills. The signs of wear are the same, a duller flavour, weaker vapour and darkened cotton. Our guide on [how to clean a vape tank](/uk/how-to-clean-a-vape-tank/) covers what to do with the tank when the coil is changed.

## Related reading

- [Vape coil ohms and watts, choosing right](/uk/vape-coil-ohms-and-watts/)
- [MTL and DTL, setting up your vape tank](/uk/mtl-and-dtl-vaping/)
- [Z Sub Ohm 2021 tank, coils and upkeep today](/uk/geekvape-z-sub-ohm-2021-tank/)
- [How to clean a vape tank, the complete guide](/uk/how-to-clean-a-vape-tank/)

## FAQ

These answers deal with the liquid itself and its formats, at the moment you fill a tank.

### Are Freeze Dragon and Freeze Ice Dragon the same e-liquid?
Several shops use the name Freeze Ice Dragon in the title of their listing. Liquideo's own pages only ever say Freeze Dragon, and the name printed on the bottle, together with the Liquideo brand, remains the best guide.

### Does Freeze Dragon come in 100 or 200 ml?
Liquideo's Freeze collection lists it in 10 ml and 50 ml only. A larger bottle sold under this name is a different pack, to be checked on its own listing.

### Which nicotine strength suits a tight draw?
The 10 ml comes at 0, 3, 6 or 10 mg/ml. With MTL vaping the volume of vapour is small, and these strengths are used as they are, with no nic shot and no maths.

### Does Freeze Dragon gunk up coils quickly?
The listed ingredients include no named sweetener or cooling agent, only propylene glycol, glycerine and flavourings. Its 50/50 base is not as thick as very high VG liquids, which gunk up a coil faster.

### Should you wait after adding a nic shot to the 50 ml?
Yes, a few minutes, once the bottle has been shaken hard. Priming the coil comes on top of that, when you fill the tank.

## Freeze Dragon Liquideo in a tank, the settings to remember

It all starts with the format. The 10 ml goes into a tight draw tank, on a coil of 1 ohm or more set low. The shortfill with a nic shot belongs in a sub-ohm tank, at a final strength that respects the coil's spec sheet, 2.86 mg/ml with one shot and 10 ml of unflavoured base.

For **Freeze Dragon Liquideo**, two habits complete the set-up, priming every new coil and changing it before the end of a large bottle. The same reading applies to any e-liquid, starting from the bottle's page and the coil's page before the tank is filled.

<em>Editorial content for adult readers only. Vaping products can contain nicotine, which is a highly addictive substance. Vaping products are not for sale to anyone under 18 in the UK. Guide Clearomiseur is an independent editorial title and this article is not a buying recommendation.</em>
